page 99
page 99
page 99
page 99
page 99
375 SE
800-00162
S10A SWING MOTOR GEARBOX MAINTENANCE CONTINUED...
12 O'CLOCK POSITION
12 O'CLOCK POSITION
12 O'CLOCK POSITION
12 O'CLOCK POSITION
12 O'CLOCK POSITION
Gear Teeth to 12 O'clock Position
Gear Teeth to 12 O'clock Position
Gear Teeth to 12 O'clock Position
Gear Teeth to 12 O'clock Position
Gear Teeth to 12 O'clock Position
VIEWED STANDING HERE
VIEWED STANDING HERE
VIEWED STANDING HERE
VIEWED STANDING HERE
VIEWED STANDING HERE
Diagram 3
Diagram 3
Diagram 3
Diagram 3
Diagram 3
MAIN ASSEMBLY - PART TWO
MAIN ASSEMBLY - PART TWO
MAIN ASSEMBLY - PART TWO
MAIN ASSEMBLY - PART TWO
MAIN ASSEMBLY - PART TWO
1. Using hoist, place cover (6) onto ring gear (4). Rotate cover until both pipe plugs (6I) are located in line with
marked location of pipe plugs (1N) on shaft side of hub. (See Diagram 4: Pipe plug timing).
2. Put lock washers (22) over shoulder bolt holes on hub.
3. Put in four shoulder bolts (18) and tighten.
4. Put lock washer (23) over bolt holes on hub.
5. Put in 16 bolts (17) and tighten.
6. Torque shoulder bolts (18) and bolts (17) to 100 ft. lbs.
7. Put “Anti-Seize” on pipe plugs (6I).
8. Install pipe plugs (6I) hand tight into cover (6).
9. Put in pipe plugs (1L) into side of hub (1G).
Pipe Plug Timing
Pipe Plug Timing
Pipe Plug Timing
Pipe Plug Timing
Pipe Plug Timing
Diagram 4
Diagram 4
Diagram 4
Diagram 4
Diagram 4
