page 106
page 106
page 106
page 106
page 106
375 SE
800-00162
ELECTRICAL MOTOR COUPLING MAINTENANCE CONTINUED...
Figure 5
Figure 5
Figure 5
Figure 5
Figure 5
Figure 6
Figure 6
Figure 6
Figure 6
Figure 6
Figure 7
Figure 7
Figure 7
Figure 7
Figure 7
4. INSERT GRID
4. INSERT GRID
4. INSERT GRID
4. INSERT GRID
4. INSERT GRID
Pack gap and grooves with specified lubricant before
inserting grid. When grids are furnished in two or more
segments, install them so that all cut ends extend in the
same direction; this will permit cover installation. Spread
the grid slightly to pass it over the coupling teeth and seat
with a soft mallet (See Figure 5).
5. PACK WITH GREASE AND ASSEMBLE COVERS
5. PACK WITH GREASE AND ASSEMBLE COVERS
5. PACK WITH GREASE AND ASSEMBLE COVERS
5. PACK WITH GREASE AND ASSEMBLE COVERS
5. PACK WITH GREASE AND ASSEMBLE COVERS
Pack the spaces between and around the grid with as
much lubricant as possible and wipe off excess flush with
top of grid. Position seals on hubs to line up with grooves
in cover. Position gaskets on flange of lower cover half
and assemble covers so that the match marks are on the
same side (see Figures 6 and 7). If shafts are not level
(horizontal) or coupling is to be used vertically, assemble
cover halves with the lug and match mark UP, or on the
high side. Secure cover halves with fasteners and tighten
to torque specified in Table 1.
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
Make certain lube plugs are installed before
Make certain lube plugs are installed before
Make certain lube plugs are installed before
Make certain lube plugs are installed before
Make certain lube plugs are installed before
operating.
operating.
operating.
operating.
operating.
COUPLING DISASSEMBLY AND GRID
COUPLING DISASSEMBLY AND GRID
COUPLING DISASSEMBLY AND GRID
COUPLING DISASSEMBLY AND GRID
COUPLING DISASSEMBLY AND GRID
REMOVAL
REMOVAL
REMOVAL
REMOVAL
REMOVAL
Whenever it is necessary to disconnect the coupling, remove
the cover halves and grid. A round rod or screw driver that will
conveniently fit into the open loop ends of the grid is required.
Begin at the open end of the grid section and insert the rod or
screw driver on the loop ends. Use the teeth adjacent to each
loop as a fulcrum and pry the grid out radially in even, gradual
stages, proceeding alternately from side to side.
