Barco Prometheus I, Safety & Instruction Manual

Page: 65 / 197

4. Lamp & Lamp House
If yes, insert the anode adaptation bushing (reference 12 image 4-40 and image 4-43) into the integrated anode support of the
UV blocker.
If no, make sure that there is no anode adaptation bushing inserted into the anode support.
12
Image 4-40
7. Remove the protective packing from the xenon lamp and gently insert the xenon lamp into the Lamp House as illustrated. Lamp
cathode fi rst, Make sure that the wire of the lamp anode is upwards oriented. While inserting the lamp, rotate it slightly, engaging
the pins (reference 11 image 4-41) of the cathode adapter in the foreseen slots. This is to ensure the lamp cathode is completely
inserted. Keep supporting the anode of the lamp with one hand once the xenon lamp is in position.
Caution: Ensure that you wear protective clothing, a full face shield and protective gloves.
Tip: Write down the serial number of the xenon lamp. You will need this while updating the lamp parameters after installation
of the xenon lamp. The serial number of the xenon lamp is engraved in the neck of the xenon lamp.
11
Image 4-41
8. Slide the anode connector in its position on the Lamp House as illustrated.
Caution: Avoid any tension on the anode wire, ensuring there is no mechanical stress on the lamp.
Image 4-42
9. Install the UV blocker assembly as illustrated. Use the opening at the side of the Lamp House to guide the anode pin of the
xenon lamp into the anode supporting mechanism of the UV blocker.
R5905963 PROMETHEUS SERIES 09/03/2015 61