6. Final Adjustment and Configuration
Barco – OverView cDG67-DL – R5976624– installation manual – Revision 03 – August-2005
______________________________________________________________
6-37
6.6.12
Disable IR
Figure 6-54
Service menu: Disable IR
By selecting this command, all OSD content will disappear and the IR will be disabled. This function is intended to
be used to close a service/maintenance session. It goes without saying, that it is impossible to re-enable IR
control by using the IR remote control unit.
IR can be enabled using the RS232 remote control, or by pressing the On/Reset button on the rear side for about
10 seconds. After this time the IR will be available again.
Press the On/Reset button for about 10 seconds to enable the IR remote control again!