Barco MDSC-8255 12G, User Manual

Page: 56 / 72

R5913964 /00 MDSC-8255 56
• Steel blades
• Cloths with steel thread
• Paper-based cloths (e.g. paper towels, facial tissues, toilet paper)
CAUTION: Read and follow all instructions on the label of the cleaning product.
CAUTION: Take care not to damage or scratch the front glass or LCD. Be careful with rings or other
jewelry and do not apply excessive pressure on the front glass or LCD.
CAUTION: When a small object or dust is tucked between the front bezel and the LCD surface (for
displays without front glass), carefully remove with a soft object such as a plastic card or finger nail.
Do not use sharp objects such as paperclips or tweezers to avoid damage to the LCD.
CAUTION: Do not apply or spray liquid directly to the display as excess liquid may cause damage
to internal electronics. Instead, apply the liquid to a cleaning cloth.
6.5 Regulatory compliance information
Indications for use
• Wall mounted in the surgical room to show multiple images.
• Second display in CatLab. The device is not intended for diagnosis.
• Can be used in the patient area only if connected to an insulation transformer.
Intended usage environment
• Equipment primarily for use in a health care facility that is intended for use where contact with a patient is
unlikely (no applied part).
• The equipment shall not be used with life support equipment.
• The user should not touch the equipment, nor its signal input ports (SIP)/signal output ports (SOP) and the
patient at the same time.
Contra-indications
This display is not intended to be used for direct diagnosis and therapeutic interventional radiology.
Intended users
Surgical displays are intended to be used by trained medical practitioners.
Notice to the user and/or patient
Any serious incident that has occurred in relation to the device should be reported to the manufacturer and the
competent authority of the Member State in which the user and/or patient is established.
Factory address
Fimi S.r.l. , Via Saul Banfi 1, 21047 Saronno, VA, Italy
Manufacturing country
The manufacturing country of the product is indicated on the product label ( “ Made in …” ).
Importers contact information
To find your local importer, contact one of Barco ’ s regional offices via the contact information provided on our
website ( www.barco.com ).
Important information