Barco FLX-24, Installation Manual, Page: 30 / 76

3. Components of an FLX display system
BARCO FLX ► This controller ► String con fi g
BARCO FLX
►
Default config
This controller
Restore
String config
Back
Address: 12
The FLX-NNI Controller contains a default pixel string
con
fi guration. This default con fi guration consist of 64 lines of 256
pixels. The fi rst 8 lines are applied to the data output port 1 (OUT
1), the next 8 to port 2 (OUT 2) and so on. The fi rst line on each
port goes to the fi rst output of its connected HUB. The second line
to the second output and so on up to eight.
This default line/pixel con fi guration allows to view content or test
patterns on the pixels connected with the FLX-NNI Controller.
The content displayed will be mixed up because the physical
location of the pixels does probably not match with the default
con
fi guration.
LOADING! PLEASE WAIT ...
Note that the pixel string con fi guration, which was set by the
Director toolset, is stored in the fl ash memory of the FLX-NNI
Controller and thus remains available for restoring.
This message will appear during the ’Restore’ action.
BARCO FLX ► This controller ► String con fi g ► Default con fi g
BARCO FLX Load will override
This controller the active config
String config
until power off/on
Default config or Restore
►
Load now
Address: 12 Back
This menu allows you to start loading the default con fi guration.
Note that the default pixel string con fi guration will overrule
the active pixel string con fi guration which was set by the
Director toolset.
Only a restore action or a power off/on action will retrieve the
original pixel string con
fi guration set by the Director toolset.
LOADING! PLEASE WAIT ...
Loading in progress ....
Calculation Creative Mask ...
Loading in progress ....
Calculation Creative Map ...
Loading in progress ....
Once the default string con fi guration is loaded, the ’String con fi g’
menu is displayed.
BARCO FLX ► This controller ► Link Errors
BARCO FLX
IN : 0
This controller TRU1:0
Link Errors TRU2:0
►
Reset
Back
Address: 12
This menu displays the counted link errors of the data IN and
data TRU connections of the FLX-NNI Controller. This is very
helpful if you see for example sparkles on the screen, or if the
communication seems to work hardly. On the LCD-display,
you see the number of errors on the input and the two output
connections. 0 means no errors, 65535 means maximum number
of errors. The error counter increments, if errors are detected,
until you press Reset (counting restarts from 0).
REMARK: A not-connected data IN port will always display
maximum number of errors (65535; just ignore this).
TIP: It may be helpful to count the errors over a very long period
of time in case errors occur exceptional. The menu doesn’t
disappear after a given time. If after a long period the error
counter is still zero, you can conclude that this path is OK.
26 R59770420 FLX-24 21/12/2009