Barco FLX-24, Installation Manual, Page: 21 / 76

3. Components of an FLX display system
1
3
2
5
4
Image 3-5
1
Left/Right alignment marking.
2 Socket cable output mark.
3 Positioning holes.
4 O-ring for IP66 sealing. Rubbed with “Inter fl on fl uor grease 2”.
5 Socket fi xation hole M3 (maximum depth = 6 mm).
Parts location of the FLX-S connector strip
1
4
2
3
Image 3-6
1
Male data plug, input side (bayonet mount locking mechanism).
2 Carrier with FLX-24 sockets mounted on PCB.
3 FLX-24 Pixel.
4 Female data plug, output side (bayonet mount locking mechanism).
C
AUTION
:
Prevent at all times that dust or dirt sticks to the O-ring of the FLX-24 pixel socket. In case the
O-ring is damaged or contaminated with dust and/or dirt the IP66 rating can no longer be guaranteed. Note
that Te
fl on spray is applied to the O-ring to ensure a good sealing without risk of degeneration of the O-ring.
Do not let an FLX-24 pixel socket unused. Always install an FLX-24 pixel upon each socket in the pixel string.
Keep the FLX-24 pixel upon the socket for storing.
Connectivity
The FLX-24 Pixel can be plugged into a molded FLX-24 socket on a cable or into a FLX-24 socket witch is mounted on a strip (PCB
board). Barco offers two standard connector strings and two standard strips:
• FLX-24 connector string for 16 FLX-24 Pixels at a pitch of 16 cm. ( R9899549 : 1 piece)
• FLX-24 connector string for 64 FLX-24 Pixels at a pitch of 16 cm. ( R9899550 : 1 piece)
• FLX-S50 strip for 16 FLX-24 Pixels at a pitch of 50 mm. ( R9899556B16 : 16 pieces)
• FLX-S25 strip for 32 FLX-24 Pixels at a pitch of 25 mm. ( R9899555B16 : 16 pieces)
R59770420 FLX-24 21/12/2009 17