Barco F70 Series, Installation Manual

Page: 5 / 22

1. F70 / F90-series multifunctional frame
1. F70 / F90-SERIES MULTIFUNCTIONAL FRAME
Purpose of the F70 / F90-series multifunctional frame
The F70 / F90-series multifunctional frame is exclusively designed for the Barco F70 and F90 projectors and can thus not be used
on any other equipment.
Overview
• Safety
• Introduction
• Before assembling the frame
• Assembling the frame
• Installing the projector onto the multifunctional frame
• Installing the additional fi lter (F90 only)
• Stacking multiple projectors using the multifunctional frame
• Suspending the projector from a truss
• Skewing the projector
• Tilting the projector
• Rotating the projector
• Dimensions
1.1 Safety
About this chapter
Read this chapter attentively. It contains important information to prevent damage to the rigging frame. Ensure that you understand
and follow all safety instructions mentioned in this chapter before installing the rigging frame. After this chapter, additional “warnings”
and “cautions” are given depending on the installation procedure. Read and follow these “warnings” and “cautions” as well.
Installation personnel
This assembly of the frame and installation of the projector must be performed by authorized and quali fi ed technical personnel only.
Single assembly only
You can only assemble the rigging frame one single time. While you can remove and install other projectors into the frame and it is
allowed to replace safety cables, it is not allowed to disassemble the rigging frame itself.
Expiry date provided adhesive
Make sure to check the expiry date of the adhesive, provided with the rigging frame. Make sure the adhesive (high strength thread-
locker) is not expired.
If expired, makes sure to get new adhesive of similar or higher strength than the one provided in the kit.
Safety Data Sheets for Hazardous Chemicals
For safe handling information on chemical products, consult the Safety Data Sheet (SDS). SDSs are available upon request via
safetydatasheets@barco.com.
Securing all screws and stacking pins
Make sure that the thread of the screws and the stacking pins are provided with the necessary amount of adhesive.
C
AUTION
:
Make sure that all the screws are suf fi ciently tightened. Respect the torque required to tighten all
screws.
Forgetting or neglecting to do this may result in an unsafe rigging frame.
C
AUTION
:
When the safety cables have undergone a heavy shock, invisible damage may have occurred to
the safety cables. In this case the safety cables must be replaced.
Maximum stacking and hanging
The projectors can be stacked on top of each other on a fl at surface, or suspended from a truss using the multifunctional frame.
R5906768 F70 / F90 MULTIFUNCTIONAL FRAME 22/11/2017 1