1. F70 / F90-series multifunctional frame
6. Install all 11 hex screws without tightening. Do this as illustrated (image 1-8). Use an 6 mm Allen wrench.
Note:
The four screws at the outer side of the rigging frame must be provided with a plain washer (reference 1 image 1-8).
Caution:
Use high strength threadlocker on ALL hex screws.
1
1
Image 1-8
7. When all screws are installed, tighten the screws.
Caution:
Make sure that all 11 screws are well tightened.
How to install the stacking pins
1. Install the top and bottom stacking pins onto the top side of the frame as illustrated.
Caution:
Provide suf
fi
cient high strength threadlocker on the inner thread of the stacking pins.
Image 1-9
Image 1-10
2. Tighten the stacking pins by hand until you feel it’s been fully tightened.
3. Turn the stacking pins back in the opposite direction until you can place the orientation rod + nut as illustrated image 1-11).
Caution:
Make sure the orientation rod is pointing precisely in the round of the corner piece. If not done precisely, the frame will
not be connectable to other frames. For more info on connecting rigging frames, see "Stacking multiple projectors
using the multifunctional frame", page 10.
2
1
3
45°
Image 1-11
6
R5906768 F70 / F90 MULTIFUNCTIONAL FRAME 22/11/2017
