4. Lamp & Lamp House
G
G
G
Image 4-24
Mount lamp house
4. Push the lamp house forward until it slides fully into the projector.
5. Secure the correct position of the lamp house by tightening all three spring lock screws as illustrated.
Image 4-25
Secure lamp house
6. Reinstall the lamp cover of the projector.
While starting up the projector, the electronics detect if a lamp is installed. If no lamp is installed, it is not
possible to start up the projector.
4.6
Resetting the lamp parameters
C
AUTION
:
The “LAMP INFO” parameters MUST be updated after each installation of an xenon lamp inside
the Lamp House. Neglecting this update will result in poor performance and short life time of the xenon lamp.
How to reset the lamp parameters?
1. Start up the projector but do not ignite the lamp.
2. Go via the
Communicator
touch panel to the menu “
Installation
” > “
Lamp
” > “
Lamp information
”.
3. While the
Lamp information
window is displayed, tap on
Reset
(1).
A reset message is displayed (2).
4. Tap on
Select
(3) to display a list of possible article numbers (4). Select a article number (5) and tap
OK
(6).
34
R5905050 DP2K C-SERIES 10/07/2012
Summary of Contents for DP2K-12C
