3. Physical installation
-
Loosen the nuts (A), using a wrench of 17 mm, on the threaded rod.
-
Adjust the height of the legs until the projected image matches the projection port window and the screen tilt.
-
Secure the leg height by tightening the nuts (A).
90°
Inclined screen
Image 3-4
Projector tilting
Barco offers a pedestal for the DP2K C-series projector. This universal pedestal allows you to easily tilt the
projector forward up to 6°.
3.2
Installation of the exhaust system
THE USE OF AN EXHAUST SYSTEM IS MANDATORY !
About Exhaust
The exhaust stack of the projector head is designed to
fi
t a 201 mm (7.91 inch) diameter duct. This size must be used throughout
the entire system and installed to eliminate any possibility of downdraft or rain dripping into the lamp house.
The exhaust blower must be capable of removing minimum 6,65 m
3
/min (235 CFM).
C
AUTION
:
If more than one projector is installed in a common projection booth, the above exhaust air
fl
ow
must be measured at EACH individual projector head exhaust stack. Inadequate exhaust draft can contribute
to premature xenon lamp failure.
How to install the Exhaust stack
See illustration below:
R5905050 DP2K C-SERIES 10/07/2012
15
Summary of Contents for DP2K-12C
