4. Lamp & Lamp House
4. Set the “
Light output mode
” in
normal mode
and the “
Lamp Dimming
” on maximum (
255
).
Note:
This window on the Communicator touch panel shows in the upper left corner the measured value of the built-in light
sensor of the projector.
Image 4-27
Light mode selection
5. Adjust the X-axis (ref X image 4-28), the Y-axis (ref Y image 4-28) and the Z-axis (ref Z image 4-28) for maximum current light
output (Footlambert Measured). Carefully turn the thumbscrew for maximum light output. Once over the maximum, turn slightly
in opposite direction to reach the maximum light output again. Do this for each direction and repeat this adjustment cycle twice.
Z
X
Y
Image 4-28
Lamp adjustment
6. Switch off the projector.
7. Reinstall the cover of the lamp compartment.
36
R5905050 DP2K C-SERIES 10/07/2012
Summary of Contents for DP2K-12C
