4. Lamp & Lamp House
Image 4-13
Remove UV blocker and side cover
2. Install the lamp cathode adaptor (reference 1) upon the xenon lamp (reference 3) as illustrated. Tighten the adapter
fi
xation
screw (reference 2) with a torque of
2,5 Nm
(1.84 lbf*ft). Use for that a torque wrench with a 5 mm Allen socket. Make sure that
there is full contact between the cathode adapter and the lamp base.
Note:
Do not take the lamp out of its protective container or protective cloth while mounting the adapter.
2,5 Nm
2
1
3
Image 4-14
Mount cathode adaptor
3. Install the anode wire lug (reference 6) upon the anode socket. Use an 17 mm open-end wrench to hold the
fi
rst nut (reference
7) while fastening the lock nut (reference 4) on the rod with a torque of
9 Nm
(6,64 lbf*ft) using a torque wrench with 17 mm
hexagon socket. Ensure that there is a
fl
at washer (reference 5) between the lock nut and the wire lug.
Caution:
Do not tighten the
fi
rst nut (reference 1) against the connector housing. There must be some play (1 mm maximum).
This is important to insert the Lamp House smoothly into the projector.
R5905050 DP2K C-SERIES 10/07/2012
29
Summary of Contents for DP2K-12C
