Quick Connect Guide
MultiSync LT150/LT85
Step1
Connect the supplied 15pin-15pin signal cable.
Connect the supplied power cable.
Step2
Step3
Turn on the projector.
NOTE: To turn off the projector, press and hold the POWER button for a
minimum of two seconds.
Power cable (supplied)
Step4
Set up the Projector
Focus ring
To adjust the projector's focus use the Focus ring on the lens.
1. Lift the front edge of the projector.
2. Press the Tilt button on the top of the projector to extend the Adjustable Tilt
Foot.
3. Press and hold the Tilt button.
4. Lower the front edge of the projector to the desired height and release the Tilt
button to lock the Adjustable Tilt Foot.
•
If the projected image does not appear square to the screen then use keystone correction for
proper adjustment. See page 31 or 37 of the supplied user's manual.
AC
IN
PC
CA
RD
US
B
VID
EO
S-V
IDE
O
RG
B
AU
DIO
PC
CO
NT
RO
L
PC
CARD
ACC
ESS
STATUS
POWER
ON
/
STAND BY
SOURCE
Always power down before you make any connections.
AC IN
PC
CA
RD
USB
VID
EO
S-V
IDE
O
RG
B
AU
DIO
PC
CO
NTR
OL
MEN
U
EN
TE
R
CANCEL
SELECT
AUTO
ADJUST
PC
CARD
ACCESS
STATUS
POWER
ON
/
STAND BY
SOURCE
VIDEO
S-VIDEO
RGB
AUDIO
PC CONTROL
RGB INPUT
1
ON
DI
P
2
3
4
5
6
Mini D-Sub 15 pin
connector
RGB cable (supplied)
For older Macintosh comput-
ers which do not have a mini
D-Sub 15 pin connector, use
a commercially available pin
adapter to connect to your
Macintosh’s video port.
AUDIO
ME
AU
T
A
PC
CA
R
STA
TUS
PO
WE
R
ON
/
STA
ND
BY
SO
UR
CE
Adjusting the Tilt Foot
ME
NU
EN
TE
R
CA
NC
EL
SE
LE
CT
AUTO
ADJUST
PC
CARD
ACCESS
STATUS
POWER
ON
/STAND BY
SOURCE
4
4
3
ME
NU
EN
TE
R
CA
NC
EL
SE
LE
CT
AUTO
ADJUST
PC
CARD
ACCESS
STATUS
POWER
ON
/STAND BY
SOURCE
1
1
2
To fine-adjust the height of the rear foot,
remove the spacer and rotate the rear foot
to the appropriate height.
Spacer
