GEO
FRONT PANEL INDICATORS
TALLY LIGHTS
Two tally lights, a red one on the left and a green one on the right.
The tally lights are controlled via the 9-pin connector named
TALLY on the rear side of the CVM.
COMP INP (ANALOG COMPONENTor DIGITAL INPUT)
Green
LED
which lights up when the component (Optional) input is
selected.
SYNC (INTERNAL / EXTERNAL SYNC)
Green
LED
which lights up when external synchronization is se-
lected.
SL/F (SLOW / FAST)
Green
LED
which lights up when the fast sync time constant is
selected.
INP1, INP2, INP3 (INPUT 1, INPUT 2, INPUT 3)
Green
LEDS
which light up when the respective input has been
selected.
GEO (GEOMETRY OVERLAY)
Red
LED
which lights up when the keyboard is set to
GEOMETRY
OVERLAY
for geometry alignment.
COL (COLOUR OVERLAY)
COL
Red
LED
which lights up whenever the monitor is set for colour
temperature alignment in manual mode or automatic mode (with an
optional Light Probe).
MONO
Green
LED
which lights up when no colour is displayed.
COMB
Green
LED
which lights up when the comb filter is selected.
The comb filter can only be selected if a
NTSC
decoder is present in
the monitor.
APT (APERTURE CORRECTION)
Green
LED
which lights up when aperture correction is enabled
.
KEY
Green
LED
which lights up when a key is pressed and accepted
(which does not mean that the action is carried out). This LED is lit
also in "Function Mode".
LIM
This red
LED
lights up whenever the upper or lower control range
limit is reached during control via the keyboard, e.g. during con-
trast, brightness and saturation setting
9
