![background image](http://html1.mh-extra.com/html/barco/coronis-1mp/coronis-1mp_system-manual_3870615079.webp)
System manual Coronis 1MP
80
BarcoMed software driver installation
mode with NO system colors. This guarantees that the all of the 256
gray levels available for GDI graphics will be present, and also
eliminates the danger that colors will change when focus moves
among different applications.
However, if you are using the Color to Gray Conversion Palette mode,
the color setting for your high-resolution grayscale displays should
default to True Color (32 bits per pixel). Even though this palette
mode supports 32 bit True Color, we recommend that when using a
using a color display in conjunction with your high-resolution
grayscale display(s) that you still set the color display as the primary
monitor.
(For more information refer to our Frequently Asked Questions page
on our website: www.barcomedical.com.)
Setting the Resolution of Your CORONIS Display Panel
1. To set the resolution for your CORONIS display panel(s), right
click on the desktop and select
“Properties”
. Select the
“Settings”
tab. Now select the
rectangle
that represents the
BarcoMed Display Controller you are working with.
SPECIAL NOTE:
If you are using the VGA capabilities of your
BarcoMed Display Controller, the resolution for that controller will
still be set to a VGA resolution of “640 x 480” pixels. If the
BarcoMed Display Controller is not running VGA, the device may
not be enabled yet. To enable the device
check
the “Extend my
Windows desktop onto this monitor” checkbox. Do not click the
“Apply”
button at this time.
If you installed your BarcoMed display drivers in SingleView mode
(default for Windows 2000) there will be one rectangle for the
virtual display representing the two heads controlled by each
BarcoMed display controller.
If you installed your BarcoMed display drivers in DualView mode
(default for Windows XP) there will be a rectangle representing
each head controlled by each BarcoMed display controller. This
will be true even if you have only one display connected to your
BarcoMed display controller. Both displays of a display controller
cannot be attached to the desktop at the same time unless their
display properties match. If necessary detach the second display
of the BarcoMed display controller you are working with by right
clicking on the rectangle that represents it, deselect
“Attached”
and click
the
“Apply”
button.
Note:
Since Windows will not let you detach the primary display
connected to a particular controller, you may need to temporarily
make another display the primary display.
Summary of Contents for CORONIS 1MP
