![background image](http://html1.mh-extra.com/html/barco/coronis-1mp/coronis-1mp_system-manual_3870615031.webp)
System manual Coronis 1MP
32
Using the USB hub
To use the display in a configuration controlled by MediCal Pro,
connect the display to the PC using the USB connector.
Also, the USB interface inside the display allows you to connect USB
devices, such as a keyboard, mouse or digital camera, to the display.
To use the USB hub:
1 Connect the display’s USB upstream connector (11) to the USB
port of the PC.
2 Connect any USB device to any of the display’s USB downstream
connectors (3) or (10).
Tilt and swivel positioning
Adjust the position of the panel for best viewing conditions.
The display foot allows adjusting the horizontal viewing angle, vertical
viewing angle and panel height.
Starting up
Proceed as follows:
1 Switch on the signal source (E.g., PC).
2 If necessary, select a suitable resolution or signal format for the
signal source.
Display installation
Summary of Contents for CORONIS 1MP
