Connections
6-5
5976065 BARCOCINE 8 10022000
75 W resistors on the module
: line terminated.
75 W resistors removed
: line not terminated.
S1 Force Negative Sync
(ON=yes)
R81
Hsync
R101
Vsync
R41
(Blue)
R21
(Green)
R1
(Red)
S2 Blue in Green (ON=yes)
Line termination 75
W
resistors
RGB Input Auto Sync Tracking Module
Procedure to remove the line termination resistors :
1
Turn off the projector and unplug the projector power cord.
2
Remove the top cover from the projector (see p.4-1).
3
Remove the RGB Input Auto Sync Tracking Module from the main frame.
4
Unsolder and remove the resistors.
To remove the RGB Input Auto Sync Tracking Module, follow the same procedure as described in chapter Installation Guidelines for
removing the Horizontal Deflection module :
1
Press the module lock and lift up the module handle;
2
Repeat this action on both sides of the module and extract the module out of the main frame.
Blue in Green Switch on the RGB Input Auto Sync Tracking Module
Blue characters are difficult to read, therefore the blue text will be displayed as cyan so that the readability becomes better.
Switch in the ON position
: Blue in Green active.
Switch in the OFF position
: Blue in Green disabled.
WARNING : Leaving the switch in the ON position will result in abnormal color balance of the projected image.
Force Negative Sync on the RGB Input Auto Sync Tracking Module
Switch in the ON position
: the sync pulses must be negative.
Switch in the OFF position
: the sync polarity will be automatically detected.