AC power connection
5-2
5976065 BARCOCINE 8 08022000
56,1 562875 5(027(
$UWQU[[[[[[[[[
6HULDOQU[[[[[[[
ART.
NR.
:RXXXXXXX
SER.
NR.
:RXXXXXXX
1
Power cord with an ANSI 73.11 plug
The wires of the delivered mains lead (power cord) are colored in accordance with the following code :
Yellow and Green
:
Ground (Earth).
White
:
Neutral.
Black
:
Live.
AC Power check
Check the power voltage which is determined by the ART. NR. (Article number) included in the label pasted on the backside of the
projector.
Projectors with the ART. NR. R9002390, R9002391 or R9002392 must be connected to a 230 VAC power source.
Projectors with the ART. NR. R9002397, R9002398 or R9002399 must be connected to a 120 VAC power source.
If the indicated voltage is different from that of the wall outlet, call a qualified technician for power adaptation of the projector.
AC Input power (mains) voltage adaptation
Adaptation of the power input of the projector between 230 Vac and 120Vac or vice versa is possible.
Follow the procedure as described below to adapt the voltage :
1
WARNING: turn off the projector and be sure the AC Power Cord is unplugged before starting the procedure !
2
Open the top cover (see 'Access to controls' in chapter Installation Guidelines).
3
Unscrew the retaining screws of the AC power input board and remove this board.
4
Pull out the 'Power selector plug' (Photo 2) and reinsert it as illustrated in Photo 3, depending on the AC power of the wall outlet
in the room.
5
Pull out the fuses and place the correct fuses in their sockets. See the table below for the correct type of fuses.
6
Reinsert the power input board and secure it with the retaining screws.
