Projector setup
4-3
5976065 BARCOCINE 8 08022000
1
2
3
4
5
6
7
8
ON
OFF
Power-up mode
When the address button on the RCU is pressed, the projector will display its own address on the screen. Once the address button
is pressed, to continue using your RCU, it is necessary to enter an address, even when the displayed address is correct. Use the
numeric keys to enter the address.
For more information, please refer to the projector Owner's Manual .
Source 2
Fh= 15.6 kHz
Fv= 50 Hz
Operational mode
When the power switch on the rear of the projector is pressed, the projector displays the last selected source if available, otherwise
it remains on that source number until the source becomes available.
The on screen indication is only available when the "Text" function is set to "ON".
Standby mode
When the power switch on the rear of the projector is pressed, the projector starts up in the standby mode. The standby key on the
RCU is used to turn the projector ON and OFF.
PROJECTOR
ADRESS
001
Powerup mode
The projector can start up in two different modes. The start-up mode is determined by the position of DIP Switch No. 4 of another
set of 8 DIP switches on the controller board (one set of 8 switches are used for projector address setting).
Position of the DIP Switch No. 4 (powerup mode) :
O N :
operational mode.
OFF:
standby mode (Factory preset).
OFF ON