Barberan RP-30-FM1, Instruction Manual

Page: 9 / 129

MAQUINARIA PARA EL ACABADO DE SUPERFICIES MACHINERY FOR FINISHING SYSTEMS
- In order to facilitate the introduction of the foil through the inside of the
evaporation tunnel, the cover of the tunnel can be opened to the rear
and pass the foil manually or whether with closed tunnel hold the
beginning of the foil with a magnetic piece upon the metallic bar which
moves to the exit turning a handwheel. Once the beginning of the foil is
at tunnel´s exit, free the magnetic piece and pull the foil manually until
after the first pressure roller.
- Situate the foil centring detector in the position which coincides
approximately with the posterior edge of the foil. This position will be
corrected afterwards when the machine is on.
- When the wrapping is done with wooden veneer and hot melt glue please
proceed as follows :
- Place some veneers upon the feeding table. The veneers must be
between 20 and 50 mm longer than the profile and the width some
more than the perimeter to be wrapped.
- Introduce a profile upon the conveyor and forward it until exceeds the
position of the first wrapping roller. Simulate manually the wrapping of
the profile and adjust the position of the guides until it touches the
edges of the simulation veneer.
- Adjust the height of the application head in order that the roller ø 80
mm situated under it makes correct pressure upon the profile.
- For the wrapping of special profiles where the beginning of the
wrapping is not done at the top of it, the first moulding roller must be
lifted up some millimetres upon the profile and situate a first wrapping
roller upon the zone where the profile starts to be wrapped.
- Place the segments of the rollers of the pressure-introduction roller of
veneer sheets in order that they reach a total width 5 mm less than the
width of the veneer to be introduced so it is avoid that the segments
which build the foil pressure roller will be impregnated with glue.