Barberan RP-30-FM1, Instruction Manual

Page: 27 / 129

The auxiliar configuration will be complete and the instrument shows Cnf on
the upper indicator.
2 Disconnect then the instrument and extract it again to place the internal
switch V2 in closed position.
3 Insert the instrument again and connect it.
4 Once the instrument is connected enter the operation parameters. (see
list).
5 After this, proceed to perform a first heating.
6 6 Press the key “SMRT” in order that the instrument makes AUTO
TUNNING, during the heating phase.7
7 Finally, go to the screen nnn , where OFF will appear at the upper side.
With the key arrow up, we will insert a number (for example 7) to close
the key in order not to permit the manipulation of any parameter, except
the two alarms and the Set Point (working port). It must remain blocked
with the light SMART on.
In order to modify the operative parameters in case it is necessary,
we must go to the screen access key to parameters nnn , and place the key
number 5000. This will permit to change the operative parameters. Once
they have been modified we will situate us in the screen nnn , and enter
again the number (7) to close the key and so block the access to the
parameters.
OFF (free key) all parameters can be modified
- Key parameter ON (blocked key) the parameters cannot be modified
See below the list of parameters and the values that must be entered
for a fix configuration.