Barazza FEEL 1FFYPPI, Technical Specifications

Page: 120 / 208

24
Do not use metal scouring pads, wire brushes
or commercially available abrasive powder
cleansers to clean the oven door as they could
scratch the surface and cause the glass to
break.
In some oven models the door may be removed
to make them easier to clean, by proceeding as
follows:
1 Open the door.
2 Turn the two clamps (F) right round. Figure 6
3 Close the door until it fits in the two
clamps. Figure 7
4 Holding the door at the sides with both
hands, raise and remove the door from the
oven until the hinges (G) have been com-
pletely removed. Figure 8
To mount the door, proceed in reverse order.
For other oven models, follow these instruc-
tions:
1 Open the oven door completely.
2 Insert the safety pins in the visible slots in
the door hinges. Figure 9
3 Hold the door at the sides with both hands
and close it almost completely.
4 Now lift the door and remove the hinges
from the slots in the front of the oven by
pulling them out. Figure 8
Caution
Do not remove the safety pins at any time
since the hinge is taut and may cause injury.
It would also be impossible to mount the door
without the pins being in place.
To mount the door, hold it with both hands and
insert the hinges in the appropriate openings
in the front of the oven. Slowly open the door
until it is fully open.
Cleaning the Oven Door
Instructions for Removing / Replacing Inner
Glass
1 Open the oven door.
2 Pull the glass outwards by the bottom (H).
Figure 10
3 The inside glass will become loose.
Remove it.
Caution
Be very careful when removing the inner glass,
as the oven door will close.
4 Clean the inner glass and the inner surface
of the oven door.
5 Return the glass supports to the upper door
slots (I). Figure 11
6 Turn the glass towards the door (K).
7 Attach the glass to the door again by push-
ing the two lower supports (L) with both
hands while pushing the glass towards the
door (M). Figure 12
Instructions to remove / replace inside glass
panels. 90 cm oven
1 Open the oven door.
2 Fully rotate the two clamps (N) to stop the
door from closing. Fig 13
3 Squeeze point 1 located on the upper part
of both sides of the oven door. Fig 14
4 Continue squeezing point 1 and pull out the
upper clasp of the door. Fig 15
5 The inside glass panels will now be loose
and can be easily cleaned with window
cleaning liquid and a soft cloth.
Warning
If the door has not been blocked with the clamp
(N), please take care when removing the inside
glass panels as the oven door will close.
Cleaning the Large Inner
Glass Door
3172539-004 EPIFA 25/06/14 12:30 Página 24