33
AUTOMATIC CONTROL OF GREASE AND CARBON FILTERS
The electronic controls with display allow automatic control of the grease and carbon filters so
that the user does not have to remember when maintenance was last carried out.
Grease filters
The grease filters should last for 40 working hours of the motor. After this time in the display
you have the letter flashing and appearing in alternative to the running speed.
If the user is changing the speed of the motor, the is no longer appearing.
When the motor is stopped, the flashing
will appear again.
Carbon filters (only if the setting is done to filtering mode)
The carbon filters should last for 1000 working hours of the motor. After this time in the display
you have the letter flashing and appearing in alternative to the running speed.
If the user is changing the speed of the motor, the is no longer appearing.
When the motor is stopped, the flashing will appear again.
RESET TO ZERO OF THE COUNTERS
When the or is flashing, and the motor is off, you can press the
+
button.
The drawer will lift up (without starting the motor) and in the display you have the 3 vertical
lines switching on, in sequence from the bottom to the top.
The or will disappear issuing an acoustic signal and you can do then all cleaning or replacing
operations.
If both filters are expired at the same time, the display will show in an alternative way and .
When this is the case the reset to zero procedure will set back to zero both counters.
Pressing any button the drawer will be closed and in the display will appear the 3 vertical lines
switching off in sequence from the top to the bottom.
To have access to the clean function without
or flashing, you can press the
+
push button
in a long way for 3 seconds when motor is off. You can clean and at the same time the counter
for grease and carbon filters is reset to zero.
MAINTENANCE
Grease filters
The metallic grease filters are positioned on the bottom of the hood and are used to contain any
grease which is normally emitted in cooking fumes, thereby impeding the deterioration of the
motor.They can be washed either by hand or in the dish washer.
For washing by hand, use hot water and soap; this can be done by hand brushing vigorously
several times and then rinsing under the tap.
After washing, the grease filters should be dried and re-fitted correctly.
It is possible that after washing the filter will have slight change in the colour.
It is advised to wash the grease filters after circa 40 hours of use of the cooking top.
If the grease filters are very dirty, the motor can only take in a small quantity of air, and
performance is reduced;
The grease which accumulates on dirty filters is easily inflammable and
can cause fires,
if they
are not removed by periodic washes.
The manufacturer declines any responsibility for fires caused by poor maintenance of the grease
filters.
Never dismantle grease flters with motor on.
Never switch aspiration on without mounted grease filters.
Summary of Contents for 1PIDZ90
