Barazza 1PIDZ90, Installation Instructions Manual

Page: 34 / 44

26
■ if the induction hob is to be installed above an oven, this must have a forced-ventilation
cooling system.
It is necessary that the appliance (oven) and the induction hob in ceramic glass
are adequately isolated, in such a way that the heat generated from the oven, measured on the
side of the bottom of the induction hob, does not exceed 60°C. Failure to follow this precaution,
could cause a malfunction in the TOUCH CONTROL system.
■
do not install the induction hob above dishwashers: if this is absolutely necessary, place a
watertight element between the two appliances.
The failure to comply with the above-mentioned precautions could lead to incorrect
functioning of the appliance.
MOUNTING INSTRUCTIONS
Mount the cooker hood as shown in the pictures of the mounting manual attached.
The cooker hood is heavy and in order to move it 2 persons are needed.
During the installation of the cooker hood, always wear protective handgloves to prevent injuries.
The appliance is developped to be installed into a working top.
Prepare the sealing material along the entire perimeter
(Fig. 2)
Block the domestic appliance into place with the supports, keeping the thickness of the surface
in mind. If the lower part of the appliance after installation is accessible from the lower part of
the furniture, it is necessary to mount a separating panel respecting the distances given.
(Fig. 1)
VENTILATION
The distance between the induction hob and the kitchen furniture or built-in appliances must be
such to guarantee sufficient ventilation and discharge of the air.
Do not obstruct the front cooling slots in order to prevent malfunctioning of the appliance.
(Fig.
3)
Do not use the induction hob if pyrolysis process is in execution in the oven.
BEFORE ELECTRICAL INSTALLATION
Before connection you must:
■
check that the building/room is fitted with electric safety system to protect against short
circuits and electric shock systems according to law in force.
■ always turn off the main voltage supply by means of the bipolar switch before connecting
and switch on again only when connections have been completed, tested and are safe.
■ the earth wire is 2 cm longer than the other cables;
■ the system ratings meet the ratings indicated on the rating plate applied in the product;
■ the system is fitted with efficient earth system in compliance with the laws and current standards.
Earthing is mandatory by law.
If the domestic appliance is not supplied with a cable and/or suitable plug, use material suitable for the
absorption value indicated on the identification plate and the operating temperature.
ELECTRICAL CONNECTION
WARNING
The product has got different speed cables.