48
6.3.1 Information about battery operation
(1) Before using the new battery, clean the surface and check for the damage. Smear
butter or vaseline on the connectors to retard corrosion.
(2) The battery is assembled on
the truck for balance weight, if it’s lower than the
min.
weight, the load capacity will be affected. When assembling the battery on the truck, fasten
it with pin. The pin must be assembled after lifting and replacing the battery. The stability of
the truck will be affected with no fixed pin.
(3) The first charge before using new battery is initial charge, after that, the current of
common charging must keep the specified value, and input capacity is 130%-150% of
output capacity, the battery must charge for about 12 hours.
(4) When operating the battery, avoid over-discharging (mean the voltage of single
battery is lower than 1.80V) and over-charging, for it will effect the usual life and
performance of battery.
(5) When charging, open the cap for pouring liquid. After finishing charging, close the
cap. Keep the vent clear, for prevent exploding and damage of battery.
(6) After using the battery, charge it in time. If not charging in time, undercharge
usually, standing idle without charging for long time or over discharging, the pole plates of
the battery will be sulfatization, which effect a decline in performance of the battery or
cause failure if seriously.
(7) There is oxygen-
hydrogen separated out when charging, it’s necessary to keep
good ventilation condition and avoid burning to keep off the explosion.
(8) During using and charging, the level of the electrolyte will decrease and the density
will increase. Usually add distilled water to keep normal capacity and density of electrolyte.
Notice: Electrolyt
e can’t be added directly.
(9) Keep the surface of the battery clean, maintain and service the pole terminals,
bolts and connectors, loose connections or poor contact must be removed in time.
(10) During using the battery, if the voltage of the single battery is uneven or the
battery is not often used, a balanced charging (an amount over charge) every month is
necessary.
6.3.2 Compound electrolyte
(1) The electrolyte of battery must be compounded with sulphuric acid and distilled
Summary of Contents for CPDS15
