6
(14) When loading and unloading goods, keep the mast vertical and the truck is in
braking state.
(15) Because the rear wheels steer your truck, the rear end swings wide when you
turn. Use care in aisles and other tight places.
(16) During operation, pay attention to the performance and condition of machinery,
hydraulic, electric and speed adjuster.
(17) Connect the power source, turn on the key switch, select the position of
directional switch, check the truck for normal operation by turning steering wheel, depress
the accelerator pedal softly to keep proper acceleration.
(18) When the voltage drops below 43.2V during operation with load, it’s necessary to
charge the battery or replace a full charged battery at once.
(19) The shift distance of control valve lever can control the speed of the lifting or
descending of the goods. When the goods are lifted or descended, the initial speed
shouldn’
t be too fast in either case.
(20) It is necessary to brake before tilting the mast forward or backward. It’s also
necessary to decelerate and tilt forward slowly so as to prevent the goods from slipping off
the rack.
(21) Tilt the mast of the high lift forklift truck as backward as possible when the truck
works. Use minimum forward and backward tilt when loading and unloading. It is
dangerous to travel or turn at high levels.
(22) On the high lift forklift truck with lifting height more than 3m, it is noted that the
goods on it will fall down, take the protection measures if necessary.
(23) The overhead guard is main part which is strong enough to meet safety standard,
and protect the operator from falling materials. It’s very dangerous to dismantle or rebuild
the overhead guard, because these conditions could lead to an accident.
(24) A load backrest shall be used as protection against back falling objects on the fork.
It’s very dangerous to dismantle or rebuild the load backrest, because these conditions
could lead to an accident.
(25) Load should be contacting with a load backrest. Do not handle the load which
exceeds height of a backrest. When loads go over the load backrest, there is a danger of
load’s falling against operator.
(26) The stability of the truck is influenced by the wind-force during outside operation,
you must notice specially.
(27) Be careful and slowly driving over a dock board or bridge-plate.
Summary of Contents for CPDS15
