Baoli CPDS15, Operation & Service Manual

Page: 12 / 87

7
(28) When travel with load, don’t tilt mast forward, don’t do handling. Don’t brake
abruptly to prevent the bulk from slipping off the forks.
(29) Drive the forklift truck to the stacked goods at a low speed, at the same time, pay
much attention to sharp and hard objects which may prick the tyres.
(30) Pay attention to pedestrian, obstacle and bumpy road when driving. Pay attention
to the clearance over the forklift truck.
(31) Keep your head, hands, arms, feet
and legs within the confines of the operator’s
compartment. Never allow other persons on the forklift truck.
(32) Crossing, turning and tilting shall not be taken on a slope. It could cause sideways
turning of the truck, it is very dangerous. On a slope, drive the truck with load forward to
ascend and backward to descend. When the truck goes down on a slope, drive slowly with
the brakes on. Make sure that the engine should not be shut down when traveling on a
slope.
(33) The starting, turning, driving, braking and stopping of the truck should be done
smoothly. When steering on the humid or slippery road, the truck should be decelerated.
(34) When operating the truck, avoid sudden stop, acceleration, stop or turn. In the
case of improper operation, the truck will turn over. In case of this, the driver must keep
calm, don’t jump off the truck. The driver must hold tightly the
steering wheel with two
hands; meanwhile, his body must incline in opposite direction of truck’s turning over.
(35) The unloaded forklift truck with attachment should be operated as a loaded truck.
(36) Check the chains periodically to make sure that good lubrication condition exists
between the chain elements, the degree of tightness between left and right chain is
identical. When there is damage on the chain during operation, if the variation value of the
chain pitch exceeds 2% of standard value, it indicates that the chains have been worn
excessively and they must be replaced immediately.
(37)
To ensure the safety of loading, don’t put th
e truck into reverse gear before it
decelerating and stopping.
(38) Don’t make a sudden braking when the truck traveling with loads.
(39) When leaving, lower the forks on the ground and let the shift lever on neutral, cut
down the electric supply. If parking on a slope is unavoidable, apply the parking brake and
wedge the wheels specially stopping for long time.
(40) When tilting the mast forward or backward to the limit or lifting the fork to the
maximum height, make the directional lever back to neutral position.
(41) Don’t adjust the control valve and relief valve at will to prevent the damage of