5
(2) Wear the safety guards, such as clothing, shoes, helmet and gloves while
operating the truck.
(3) When the distance between the gravity center of loads and the fork arms is 500mm,
the max. capacity is the rated capacity. When the distance exceeds 500mm, the capacity
shall be based on the load chart. Handle only loads within the allowable capacity of the
truck. The goods handled should not exceed the rated capacity of the truck.
(4) Operate your truck on a hard ground. Operate on other ground, the lift capacity and
travel speed must be decreased. Wipe off the oil and grease on the floor.
(5) Daily maintenance services should be done before or after using the truck. Anytime
you find that the truck is not functioning normally, operation of the truck should be halted
and check or repair at once.
(6) When operate one lever, don
’
t shift another leve
r. Don’t operate the lever at any
position out of the driver seat.
(7) Don’t handle unfixed or loose goods. Be careful to handle bulky goods. To prevent
the collapse of stacked goods, tighten them. Forbid loading loose or little volume goods
without tray.
(8) If the truck is equipped with a load-handling attachment, its usage sphere will be
wider, but its allowable load and stability is reduced. The attachment and special device is
not to be diverted to any other purpose. It’s very dangerous to rebuild the
attachment.
Please read the additional instruction we supplied and operate the truck following it strictly.
(9) Fork can not be used to pull out any embedded goods, if necessary, the pulling
force should be estimated.
(10) Insert forks deeply under goods.
Adjust fork’s distance according to the
dimension
of goods. Make the loads distribute on the forks evenly to avoid tilt and slide of goods.
Don’t pick the loads with one fork tip.
(11) When handling bulky loads which restrict your vision, operate the forklift truck in
reverse or have a guide.
(12) When loading the goods, lower the forks to the floor. After the fork inserting
stacked goods, the fork arms should be in contact with the goods. Drive the truck with mast
tilting back for stabilizing the load. Before traveling, raise the forks for 200mm-300mm from
the floor.
(13) While mast’s lifting and lowering, anyone is absolutely prohibited from standing
under the lifting rack or being lifted with forks. Never permit anyone to stand or walk under
upraised forks.
Summary of Contents for CPDS15
