26
2.1.3 Connecting the brake system and drive unit
There are two connectors in the joint of drive unit and brake system, one used for
connecting the traveling brake pipe while the other is used for the exhausting of traveling
brake system. See it as Fig2-3.
a) Connecting of traveling brake
Connect the brake pipe connector and brake pipe with the torque 12-16Nm.
b) Connecting of parking brake
Connect the brake cable connector and parking brake lever.
2.1.4 Exhaust of brake system (Fig.2-3)
Exhaust the air mixed in brake system after
assembling the brake system and replenishing the
brake fluid, and do it as follows:
a) Release the exhaust valve to the position
where the brake fluid can be flowed.
b) Press the brake pedal again and again, then
the pressure from brake fluid can exhaust the air
mixed in brake system.
c) When there is only brake fluid after
exhausting the air, press the brake pedal and tighten
the plug. Fig.2-3
d) Release the brake pedal and check the braking, if not brake well, do the exhausting
again and again until braking well.
2.1.5 Parking brake device
The parking brake device consists of parking brake
unit and brake cable. The parking brake unit is of ratchet
wheel type. Handle the brake lever to make the brake
cable run. Make the brake lever in an appropriate position
by adjusting the stroke of the brake cable.
If you want to release the parking brake position,
press the button in the top of brake lever.
Fig.2-4 Parking brake device
NOTICE: When the hand brake is in initial position, make the drive wheel roll
freely.
Summary of Contents for CPDS15
