Banner DF-G2 High Speed Expert, Quick Start Manual

Page: 5 / 9

Operating Instructions
Remote Input
For more information about how to perform TEACH/SET methods and to program the sensor remotely, see
www.bannerengineering.com and search 178236.
Run Mode
Run mode allows the sensor to operate normally and prevents unintentional programming changes. The +/SET/- rocker
button is disabled during RUN mode, except when using Window SET, see Window SET on page 6.
In RUN Mode, the SET function of the +/SET/- rocker button allows the user to toggle between the threshold center value
and the total number of counts on the Green display. If the Totalizer function is enabled, the total counts value increments
to the programmed value and then starts over at 0. If the Totalizer function is disabled, the total counts value increments
to 9999 and then starts over at 0. Changing any operational setting causes the total counts value to reset to 0.
Program Mode
(+)
or
(-)
to set value
(+)
or
(-)
to set value
(+)
or
(-)
to set value
(display flips 180˚)
Click SET
to enter choice list
Press and hold SET to exit choice list without saving
DISPLAY
LOOP
Return to Menu List
PROGRAM MODE
Mode Switch
to “PRG”
Click SET
to enter choice list
DISPLAY
LOOP
Click SET
to enter choice list
Click SET
to enter choice list
Click SET
to enter choice list
Click SET
to enter choice list
Click SET
to enter choice list
DISPLAY
LOOP
Click SET
to enter choice list
DISPLAY
LOOP
To scroll through menu lists: Press “+” or “-”
To enter a choice list or to select and save: Click SET
To exit a choice list without saving: Press and hold SET for 2 seconds
+
-
SET
rocker button
Click SET to select and save a choice in any list
Menu
List
on display represents a “w” on display represents a “m”
(+)
or
(-)
to set value
Figure 2.
Program (PRG) mode allows the following settings to be programmed in the DF-G2
DF-G2 High Speed Expert
™
Dual Display Small Object Counter
P/N 178061 Rev. E www.bannerengineering.com - Tel: +1-763-544-3164 5