BANDIT CONTROLS - CE
Bandit
81
13
245840062970 8Oct2018
Setup Page
FuelSaver
If Fuel Saver Mode is turned on, the machine will throttle down to on its own to 1200rpm low idle if it runs too
long with no load. Two settings affect Fuel Saver mode.
1. FuelSave Time: this is the amount of time the machine will wait at "no load" until it idles down (as selected
on SETUP1, see page 7).
2. FuelSave Load: based on engine percent torque load; anything below this setting is considered "no load".
Ex settings: 30seconds, 48% load.
During normal operation the load on the engine might range from 50-100% while chipping. When no material
is being fed into the chipper it will just run at high rpm but maybe only 38% load. With actual load being lower
than the 48% setting, the controller sees "no load" and after 30 seconds will throttle the machine to 1200rpm.
(Note: if operator throttles down to low idle while Fuel Saver is ON, the Fuel Saver controls will throttle the
machine to 1200rpm as normal, which in some cases might slightly
increase
eng speed).
Press Throttle Up to bring the RPM back to full speed.
The buttons on the infeed are tied into Throttle Up.
When you turn Fuel Saver OFF, the machine will throttle down to
idle, EXCEPT if engine RPM is above AutoFeed Hi setting. In this case,
the controller assumes the operator is at full engine speed and
wants to keep working.
1
2
3
4
5
1
2
3
4
5