12
3/19
MODEL 12XP CE
DECALS
DECALS
Decals located on your Bandit equipment contain
useful information to assist you in operating your
equipment safely. Some of the decals on your
machine and their location are shown in this section.
1. You should use soap and water to keep your
decals clean. Never use mineral spirits or any other
abrasive cleaners.
2. Immediately replace any missing or damaged
decals. The location the decal is going to be applied
to must be clean and dry, and at least 40°F (5°C)
before applying decal.
3. When the need arises to replace a machine
component with a decal attached, be sure and
replace the decal.
4. Replacement decals are available, and can be
purchased from the manufacturer or your Bandit
Dealer.
5. Peel back about half of the backer paper on the
decal. Position it on the flat, dry, clean surface so it
is smooth and secure. Peel off the remainder of the
backer paper as you continue to stick the decal on
the surface.
6. Rub decal from the center outward to remove air
bubbles and to secure contact.
7. English decals are typically standard. Other
foreign language decals are available and may be
purchased. Mail translated decals required to Bandit
Industries, Inc.
It is very important that all decals remain in place
and in good condition on your machine. Please follow
the care and instructions given below.
THE CLUTCH SHOULD
NOT
BE ENGAGED
OR DISENGAGED AT ENGINE SPEEDS ABOVE
LOW IDLE.
DO NOT operate this Clutch/PTO unless proper adjustments and
lubrication are maintained per the Clutch/PTO Manufacturer’s Manual.
Different brands and models require different service and operation
procedures. New Clutch/PTO’s require more frequent adjustment.
GOOD OPERATORS
DON’T WASTE MONEY!
Clutches will fail, glaze over, and burn up from improper
adjustment. This will cost the owner of this machine
thousands of dollars to repair. A well maintained, correctly
adjusted clutch should function properly for years.
N-07 1/18
NOTICE
LEAVING THE CLUTCH DISENGAGED EVEN
FOR SHORT PERIODS OF TIME WILL
REDUCE PILOT BEARING AND CLUTCH
PLATE LIFE! REFER TO CLUTCH MANUAL FOR
OPERATING AND MAINTENANCE PROCEDURES.
CE-11 11/18
CE-20 11/18