1.
Approach the port end of the start line.
2.
When the boat reaches the port end of the start line, open the menu and select
Start
Line
,
Port end
, and then
Ping port
. The port end mark on the start line panel becomes
solid red, indicating it is set.
3.
Approach the starboard end of the start line.
4.
When the boat reaches the starboard end of the start line, open the menu and select
Start Line
,
Starboard end
, and then
Ping Starboard
. The starboard end mark on the
start line panel becomes solid green indicating it is set.
The start line end points are set and can be viewed on the Chart panel and Start line panel.
Setting end points at cursor position
1.
Open the Chart panel and move the cursor to the position in the chart where you want
the port end point to be.
2.
Open the menu and select
Start line
,
Port end
, and then
Set at cursor
.
3.
Repeat steps 1 and 2 for the starboard end point.
The start line end points are set and can be viewed on the Chart panel and Start line panel.
Setting end points at coordinates
Select the
Set coordinate Port
and then the
Set coordinate Starboard
menu options to
enter the coordinates of the port and starboard end points.
Setting end points from each other
Use the
Set from stbd Port
and
Set from port Starboard
menu options to set the Range
and Bearing of the end points from each other.
Removing end points and the start line
Use the
Clear Port
or
Clear Starboard
menu options to remove the start points. When
both are removed, the start line is removed.
50
Race panel
| Zeus3 Operator Manual
Summary of Contents for Zeus3 Glass Helm
Page 1: ...ENGLISH Zeus3 Operator Manual www bandg com ...
Page 2: ......
Page 140: ... 988 11377 001 0980 ...
