SENSOR
MAGNET
IMPUT
CLAMPS
OPEN
STOP
PRESSURE
SAFETY DEVICE
OPENING
LIMIT SWITCH
CLOSING
LIMIT SWITCH
CLUTCH
PHOTOCELLS
START/STOP
- 6 -
CHECKS TO BE DONE BEFORE
PROGRAMMING THE BOARD
• The segments on the display corresponding to STOP, PRESSURE SAFETY DEVICE and PHOTOCELLS
must be lit. These input contacts must be normally closed. (FIG.1)
• If the board for the electronic clutch is present, turn with the hand the motor shaft and verify that the
small dot on the display goes on every time the magnet pass in the sensor range. (FIG.2)
