Balluff BMD 1H Series, Condensed Manual

Page: 28 / 98

10
ÏÏÏƖº¹ÄÄÍŰƖ»ÇÅ
4 Connecting to power supply
5
4
4
5
9
-E
N-1
7
0
7
1
2
ÇÍ»¹ÆŲƼ¾ÍÊÌÀ½ÊÁƾÇÊŹÌÁÇÆÇÆÌÀ½Å¹ÐƖÏÁʽ»ÊÇËËƘ˽»ÌÁÇÆÍƼ½Ê
" Technical data - Electromechanical data ".
7. Check the hold of the wires in the terminals by lightly pulling on
them
˅Ɩ ÇÆƽ»ÌÌÀ½Ë»Ê½½ÆÌÇÌÀ½ÁÆ̽ÊƹĿÊÇÍƼ̽ÊÅÁƹÄƓ»ÇÆƽ»ÌÌÀ½
½Ð̽ÊƹĿÊÇÍƼ̽ÊÅÁƹÄÌÇÈÇ̽ÆÌÁ¹Ä½É͹ÄÁ˹ÌÁÇÆ
9. Tighten the compression nut of the cable entry gland. The seal
ring must completely encircle the cable
10. Reinsert the display and adjustment module, if one was installed
11. Screw the housing lid back on
À½½Ä½»ÌÊÁ»¹Ä»ÇÆƽ»ÌÁÇÆÁËŲÆÁËÀ½¼Ɩ
4.2 Wiring plan, single chamber housing
À½¾ÇÄÄÇÏÁÆ¿ÁÄÄÍËÌʹÌÁÇƹÈÈÄÁ½ËÌÇÌÀ½ÆÇÆƘÐƓÐƘÁ¹¹Æ¼ÐƘ¼ƘÁ¹
νÊËÁÇÆƖ
5
1
2
+
( ) (-) 6 7 8
4...20mA
2
3
4
1
Fig. 7: Electronics and terminal compartment - single chamber housing
1 Voltage supply, signal output
2 For display and adjustment module or interface adapter
3 For external display and adjustment unit
4 Ground terminal for connection of the cable screen
Electronics and terminal
compartment