Baldor VS1SD, Installation & Operating Manual

Page: 81 / 192

Parameter Descriptions 7-7 MN766
Block Title
Parameter (Number)
Selection (Value)
Parameter Name and Description
INPUT
SETUP
(Continued)
CURR LMT SOURCE (1415) Preset Value: 0
Range: 0 - 9
None (0) Turns off external current limit.
Analog In1 (1) Connect a 10Kohm pot at J1 or connect a 0-10VDC signal to J1-2 and J1-1.
Analog In2 (2)
Connect a 0-5V, 0-10V, ±5V, ±10V, 0-20mA or 4-20mA source to J1-4 and 5.
4-20mA should be considered when a long distance (up to 50 ft) between
the external device and J1-4 and 5 of the control is necessary.
Keypad (3) Turns off Current Limit Source from Keypad.
Composite Ref (4) See Chapter 11 for more information.
Opt1 Ana In1 (5)
Selects analog input from high resolution analog input/output Expansion
Board (EXBHH005) mounted in expansion slot 1.
Opt1 Ana In2 (6)
Selects analog input from high resolution analog input/output Expansion
Board (EXBHH005) mounted in expansion slot 1.
Opt2 Ana In1 (7)
Selects analog input/output Expansion Board (EXBHH005) mounted in
expansion slot 2.
Opt2 Ana In2 (8)
Selects analog input/output Expansion Board (EXBHH005) mounted in
expansion slot 2.
Network (9) Selects the network current limit word as the current limit source.
Selects the external current limit reference to be used, converts it internally
to a percentage and then sets the torque limit of the drive as a percentage of
the drive’s Peak Current Level (P2006).
SLEEP MODE (1416) Preset Value: 0
Range: 0 - 1
Off (0) No action.
On (1)
Disables control when Command Source is less than CMD Sleep Band
(P1417). Active in all speed modes.
CMD SLEEP BAND (1417) Preset Value: 0.00
Range: 0.00 to 100.00%
Disables the control when Command Source is less than CMD Sleep
Band (P1417). Active in all speed modes and is also applied to the torque
reference when in torque mode.
Table 7-1 Level 1 Parameter Block Defi nitions Continued