Baldor VS1SD, Installation & Operating Manual

Page: 143 / 192

Monitor and RTC Description 12-1 MN766
Chapter 12
Monitor and RTC Description
12.1 Monitor Parameters (P0001 to P0818)
Monitor parameters can be viewed using the WorkBench software. Most are read only (P0001) but some (P0052) can be
written as well.
Table 12-1 Monitor Parameters Descriptions
P# Type Name Unit Help
1 SOFTWARE VERSION Software Version. - Drive fi rmware version number
2 LOC/REM STATUS
Local/Remote Status. - Source of run/stop commands. Local for keypad
or Remote for terminal block
3 DRIVE STATUS Drive Enable Status. - 0 for disabled, 1 for enabled
4 MOTION STATUS
Motion Status. - Status: stopped, forward, reverse, bipolar, sleep,
homing, etc.
5 MOTOR VOLTS V Motor Volts. - Estimated line-to-line drive output RMS voltage
6 MOTOR CURRENT A Motor Current. - Measured motor RMS current
7 MOTOR ABS SPEED RPM Motor Absolute Speed. - Estimated or measured absolute rotor speed
8 POSITION COUNTER CNT
Position Counter. - Accumulated count in revolutions and counts for
feedback device.
9 SPEED REF Hz
Speed Reference. - Setpoint speed for motor. Command source
parameter determines the source
10 ABS SPEED DEMAND Hz Absolute Speed Demand. - Absolute speed output from Speed Profi ler.
11 SPEED DEMAND Hz Speed Demand. - Signed speed output from Speed Profi ler
12 ABS MOTOR FREQ Hz Absolute Motor Frequency. - Estimated motor electrical frequency
13 MOTOR FREQ Hz Motor Frequency. - Signed motor frequency
14 DRIVE TEMP °C Drive Temperature. - Measured temperature of drive heat sink
15 BUS VOLTAGE V
Bus Voltage. - Measured bus voltage. DC bus high fault occurs above
400/820V DC
16 OVERLOAD LEFT %
Overload Remaining. - Current overload count remaining until overload
fault/foldback occurs
17 INPUTS
Digital Inputs. - State of terminal block digital inputs. Off/On indicated
by 0/1
18 OUTPUTS
Digital Outputs. - State of the terminal block digital/relay outputs. Off/On
indicated by 0/1
19 R/W RATED HP HP Rated Horsepower. - Drive rated horsepower
20 R/W RATED CURRENT A Rated Current. - Nominal/derated drive continuous RMS current rating
21 R/W RATED PK CURRENT A
Rated Peak Current. - Nominal/de-rated drive peak, short term, current
rating
22 R/W RATED VOLTS V Rated Voltage. - Nominal voltage rating of drive
23 ACTIVE FAULTS Active Faults. - Number of active / simultaneous drive faults
24 ACTIVE FLT CODE Active Fault Code. - Currently active drive fault code number
25 PROC FEEDFORWARD % FF Process Feedforward. - Process PID feed forward signal
26 PROC SETPOINT % SP Process Setpoint. - Process PID set point signal