![background image](http://html1.mh-extra.com/html/baldor/nextmove-pci/nextmove-pci_installation-manual_3560228055.webp)
Operation 5-13
MN1903
6. To remove the demand and stop the test, type:
STOP.0
This should cause the demand produced at
the Demand 0 output to become 0V.
5.4.2 An introduction to closed loop control
This section describes the basic principles of closed loop control. If you are familiar with
closed loop control go straight to section 5.5.1.
When there is a requirement to move an axis, the NextMove PCI control software translates
this into a demand output voltage. This is used to control the drive (servo amplifier) which
powers the motor. An encoder or resolver on the motor is used to measure the motor’s
position. Every 1ms* (adjustable using the
LOOPTIME
keyword) the NextMove PCI compares
the demanded and measured positions. It then calculates the demand needed to minimize the
difference between them, known as the
following error
.
This system of constant measurement and correction is known as closed loop control.
[
For the analogy, imagine you are in your car waiting at an intersection. You are going to go
straight on when the lights change, just like the car standing next to you which is called
Demand
. You’re not going to race
Demand
though - your job as the controller (NextMove PCI)
is to stay exactly level with
Demand,
looking out of the window to measure your position
].
The main term that the NextMove PCI uses to correct the error is called
Proportional gain
(
KPROP
). A very simple proportional controller would simply multiply the amount of error by
the Proportional gain and apply the result to the motor [
the further
Demand
gets ahead or
behind you, the more you press or release the gas pedal
].
If the Proportional gain is set too high overshoot will occur, resulting in the motor vibrating back
and forth around the desired position before it settles [
you press the gas pedal so hard you go
right past
Demand.
To try and stay level you ease off the gas, but end up falling behind a little.
You keep repeating this and after a few tries you end up level with
Demand,
travelling at a
steady speed. This is what you wanted to do but it has taken you a long time
].
If the Proportional gain is increased still further, the system becomes unstable [
you keep
pressing and then letting off the gas pedal so hard you never travel at a steady speed
].
To reduce the onset of instability, a term called
Velocity Feedback gain
(
KVEL
) is used. This
resists rapid movement of the motor and allows the Proportional gain to be set higher before
vibration starts. Another term called
Derivative gain
(
KDERIV
) can also be used to give a
similar effect.
With Proportional gain and Velocity Feedback gain (or Derivative gain) it is possible for a
motor to come to a stop with a small following error [ Demand
stopped so you stopped too, but
not quite level
].
The NextMove PCI tries to correct the error, but because the error is so small the amount of
torque demanded might not be enough to overcome friction.
*
The 1ms sampling interval can be changed using the
LOOPTIME
keyword to either 500µs or
200µs.
Summary of Contents for NextMove PCI
