Baker Double Notcher - Rev 2, 09/07
;
WWW.BAKER-ONLINE.COM
27
Replacing Radius End Cutter Disc Inserts
The inserts on both ends of the cutter head are circular in shape. They require the same
maintenance, but are replaced in a different manner.
Turn machine off and lock-out / tag-out electrical panel.
Remove the hex head bolt and washer located in the center of the round disc.
Remove the old end cutter disc and ensure seat area is clean and free of debris.
Insert new 1” radius carbide cutter disc.
Reassemble and tighten using the same washer and bolt.
Note:
We recommend rotating the radius end cutter disc inserts approximately 1/3 of its
diameter every 2 weeks and replace them after 3 rotations.
Figure 27
Radius end cutter disc insert
Washer
Hex head
bolt
