Baker Double Notcher - Rev 2, 09/07
;
WWW.BAKER-ONLINE.COM
20
To Begin Processing Material
Complete a visual inspection to ensure all guards/covers are in place and secure.
Raise tabletop to clear cutter heads prior to starting motors.
Turn on electrical power via the main electrical panel.
Turn on air supply.
Pull up on the ALL STOP button until it illuminates (
Figure 20
).
Pull up on the SAW # 1 button to start the first cutter head. Wait until the motor starts and
is running at full speed, then pull up on the SAW # 2 button to start the 2
nd
cutter head.
Lower table top to the desired cutting position / depth.
Turn the feed switch to the ON position.
If your machine is equipped with a descrambler deck, turn the DESCRAMBLER switch to
the ON position.
Load the descrambler with material.
Note: If you have a hopper feed, an arrangement of the proximity switches (Page 21) tells
the conveyor to stop when a certain amount of wood is in the hopper. When the wood falls
below a certain level, the conveyor will start feeding the hopper again automatically.
Note:
Also always remember to raise the table when shutting off the motors.
Figure 20
