Baker Double Notcher - Rev 2, 09/07
;
WWW.BAKER-ONLINE.COM
15
Adjusting the Table Top
Raising or lowering the tabletop is controlled by a table height adjuster crank handle, located
on the left front side of the table on the in-feed end of the machine.
To raise the tabletop, loosen the two (2) adjustment nuts on the holding bolts that are
positioned on all four corners of the frame – eight (8) total.
Turn the table height adjustor crank clockwise (a left to right motion) to raise the table’s
height.
When raised to the desired height, position the holding bolts until they come in contact
with the bottom of the table, using the two (2) adjustment nuts.
To lower the tabletop, repeat the steps above, but turn the table height adjustor crank
counter-clockwise (a right to left motion).
Re-position the holding bolts and tighten the two (2) adjustment nuts located on each of
the four corners – eight (8) total.
Table Top
Adjustment Nuts
Notch Location
Adjusting Crank
Table Height
Adjustor Crank
Holding Bolt
Figure 15
