INTRODUCTION
I-E96-117B
A - 1
APPENDIX A - NTCS04 CONTROLLER/STATION
TERMINATION UNIT
INTRODUCTION
The IISAC01 Analog Control Station uses the NTCS04 Control-
ler/Station Termination Unit for termination. Configure the
termination unit dipshunts according to the assembly revision
level you are using. All NTCS04 termination units have two
analog inputs available to each station connector.
One dipshunt (XU8) on the NTCS04 termination unit selects
the analog inputs for both station connectors. Table
shows
the dipshunt configuration and analog inputs for both station
connectors (two stations per termination unit can have
bypass). All other dipshunt settings on the NTCS04 termina-
tion unit relate to the IMCIS02 Control I/O Slave Module. Refer
to the
IMCIS02 Control I/O Slave Module
product instruction
for information about setting the dipshunts for the module.
Figure
shows the NTCS04 termination unit terminal
assignments.
NOTE: Use the NKCS02 or NKCS12 termination unit to station
cable (for interconnection) to access both analog inputs.
Table A-1. NTCS04 Termination Unit Dipshunt Configuration
Analog input (with Station Feedback)
Application/Signal Type
Dipshunt Configuration XU8 (Station
Designator/Analog Input)
Station 1 (P2 connector) station/
termination unit A/I designation
Station 2 (P3 connector)
TP25080B
1 2 3 4 5 6 7 8
(A I2/A I1) (A I1/A I3)
(A I2/A I2) (A I1/A I4)
1 2 3 4 5 6 7 8
