INSTALLATION
INSERTING AND REMOVING THE ANALOG CONTROL STATION
3 - 22
I-E96-117B
®
Connecting Termination Cables to Station Housing
The termination cable edge connector snaps securely into
place in the back of the station housing. Partially remove the
station from the housing before fastening the cable to the
housing. Viewing the station housing from the rear, the cable
fastens to the right side of the station housing.
If the cable connector does not fit properly in the housing, do
not force the connector into position. The connector slots in the
housing contain small notches that allow the connector to be
inserted one way. Be aware of these notches when inserting the
connector in the station housing.
INSERTING AND REMOVING THE ANALOG CONTROL STATION
Insert the analog control station in its housing only after the
proper connections are made. Be sure to observe special han-
dling procedures when handling electronic circuitry. Before
inserting the station in its housing verify that:
1. The termination cable is properly connected to the termina-
tion unit and to the correct slot of the station housing.
2. All station operating and display options have been
selected and recorded.
Inserting the Analog Control Station
To insert the SAC station in its housing:
1. Facing the front of the station housing, align the upper and
lower edges of the circuit board with the upper and lower guide
rails on the left hand side of the station housing.
2. Open the legend door. Insure the captive screw is loose.
3. Push on the left edge of the SAC station faceplate, sliding
the circuit board into the housing until P1 on the SAC station
circuit board seats in the cable connector at the rear of the
housing.
CAUTION
Remove a station from its housing before installing or remov-
ing the station cable to the station housing. Failure to observe
these precautions could result in equipment damage.
ATTENTION
Retirer le poste de son boitier avant d’installer ou de retirer le
câble du poste du boitier. Un manquement à cette précaution
pourrait causer des dommages à l’équipement.
