62
62
Cleaning
Cleaning the saw is relatively easy. Vacuum excess wood chips and sawdust, and wipe off the
remaining dust with a dry cloth. If any resin has built up, use a resin dissolving cleaner to
remove it.
After cleaning, treat all unpainted cast iron and steel with a non-staining lubricant.
Occasionally it will become necessary to clean the internal parts with more than a vacuum. To
do this, remove the table top and clean the internal parts with resin/pitch dissolver or mineral
spirits and a stiff wire brush or steel wool.
Make sure the internal workings are dry before using the saw again, so that wood dust will not
accumulate. If any essential lubrication is removed during cleaning, re-lubricate those areas.
Summary of Contents for TS-1040C
