Baileigh TS-1040C, Operator'S Manual

Page: 20 / 84

17
17
ASSEMBLY
1. On a clean surface that will not scratch the finish,
lay out two of the stand legs (A) and a short upper
panel (B) and a lower support (C).
2. When installing the fasteners, hand tighten only
until the stand is assembled. Then square the stand
and final tighten all 24 fasteners.
3. Place the short upper panel to the inside of the legs.
Use the location dimples to assist in alignment and
install (4) M8-1.25 x 16 carriage bolts, (4) 8mm flat
washers, and (4) M8-1.25 hex nuts.
4. Attach the lower support (C), as shown, with (2) M8-
1.25 x 16 carriage bolts, (2) 8mm flat washers, and
(2) M8-1.25 hex nuts.
5. Using the location dimples, place a long panel (D)
to the inside of each of the legs and install (3) M8-
1.25 x 16 carriage bolts, (12) 8mm flat washers, and
(12) M8-1.25 hex nuts to fasten the long panels to
the legs.
6. Install the remaining two legs to the long panels and
then install the remaining short upper panel and the
lower support.
7. Place the stand on its feet.
8. Square the stand from corner to corner and final
tighten all 24 fasteners.
WARNING:
For your own safety, DO NOT connect the machine to the
power source until the machine is completely assembled and you read and
understand the entire instruction manual.