Baileigh TS-1040C, Operator'S Manual

Page: 24 / 84

21
21
32. Slide (4) M8-1.25 x 20 T-slot bolts into the slot in
the right front rail, then insert the bolts into the
mounting holes in the extension wing and main
table.
33. Slide the two pins on the end of the right front rail
into the holes in the left rail.
34. Secure the right front rail with the (4) 8mm lock
washers and (4) M8-1.25 hex nuts. Do not fully
tighten the fasteners yet. Also, install the right rail
cap with two M4 x 10 tap screws.

If the wings were not even with the table top in
Step 23, loosen the wing mounting fasteners.
Place a straightedge across the front of the
table and front of the extension wings. Gently lift
or push down on the wings. When the front of
the table and wings are even, tighten the
fasteners that mount the front of the wings to the
table.

Repeat the process above in similar manner for
the table and back of the extension wings.
When the back of the wings are even with the
back of the table, tighten the rear wing mounting
fasteners.
35. Thread the fence handle into the fence, then mount
the fence on the front and rear rails and to the right
of the blade.