Baileigh TS-1040C, Operator'S Manual

Page: 23 / 84

20
20
23. Place the straightedge across the extension wings
and main table to make sure that the combined
table surface is flat.

If the combined table surface is flat, proceed to the
next step.

If the outside end of the extension wing tilts up or
down, you will have to adjust the wings evenly with
the table when instructed later in the assembly
process.
24. Install the left rear rail onto the table and left
extension wing with (3) M8-1.25 x 20 hex bolts, (3)
8mm lock washers, and (3) M8-1.25 hex nuts. Do
not fully tighten at this time.
25. Install the right rear rail onto the table and right
extension wing with (3) M8-1.25 x 20 hex bolts, (3)
8mm lock washers, and (3) M8-1.25 hex nuts. Do
not fully tighten at this time.
26. Align the bottom of the rails with the bottom edges
of the cast iron table, so the top of the rails are flush
with each other and parallel with the table and
extension wings. Completely tighten the fasteners
on the rear rails that mount it to the cast iron table.
27. Turn the lock knob that secures the table insert so it
is parallel to the inner slot.
28. Remove the insert and set it aside, then raise the
blade up all the way.
29. Slide (2) M8-1.25 x 20 T-slot bolts into the slot on
the left front rail tube.
30. Insert the bolts into the corresponding holes on
the extension wing and main table, and then
align the right edge of the left front rail with the
saw blade.
Note: A straightedge can be used to
align the right edge of the left front rail with the
blade.
31. Snug the front left rail with (2) 8mm lock washers and (2) M8-1.25 hex nuts. Do not fully
tighten the fasteners yet. Also, install the left rail cap with two M4 x 10 tap screws.