Baileigh TS-1040C, Operator'S Manual

Page: 19 / 84

16
16
INSTALLATION
IMPORTANT:
Consider the following when looking for a suitable location to place the machine:

Overall weight of the machine.

Weight of material being processed.

Sizes of material to be processed through the machine.

Space needed for auxiliary stands, work tables, or other machinery.

Clearance from walls and other obstacles.

Maintain an adequate working area around the machine for safety.

Have the work area well illuminated with proper lighting.

Keep the floor free of oil and make sure it is not slippery.

Remove scrap and waste materials regularly, and make sure the work area is free from
obstructing objects.
It is important to maintain free area of
30
” (762mm) around the machine, which
is required for the working place. If any
long material is machined, it is
necessary to have a sufficient room in
front of the machine as well behind it in
the places of material input and output.
Before beginning assembly, take note of
the following precautions and
suggestions

The machine is bolted to the pallet. Before attempting any of the assembly procedures
remove all the loose parts and hardware from the inside of the machine and unbolt the
machine from the pallet.

FLOOR: This tool distributes a large amount of weight over a small area. Make certain that
the floor can support both the weight of the machine and the operator. The floor should also
be a level surface. If the unit wobbles or rocks once in place, be sure to eliminate by using
shims.

WORKING CLEARANCES: Take into consideration the size of the material to be processed.
Make sure that you allow enough space for you to operate the machine freely.

OUTLET PLACEMENT: Outlets should be located close enough to the machine so that the
power cord or extension cord is not in an area where it would cause a tripping hazard. Be
sure to observe all electrical codes if installing new circuits and/or outlets.