Baileigh TS-1040C, Operator'S Manual

Page: 22 / 84

19
19
15. Secure the stand to the table saw body with (4)
M8-1.25 x 20 hex bolts, (8) 8mm flat washers, and
(4) M8-1.25 hex nuts.
16. With the assistance of two other people, turn the
saw upright on its feet. DO NOT ATTEMPT THIS
BY YOURSELF!
17. Place a level on the saw table, level the saw from
side-to-side and front-to-back by adjusting the feet,
then fully tighten all the stand fasteners with a
13mm wrench (or socket).
18. Remove the cap screw, lock washer, and flat
washer from the blade tilt shaft.
19. Slide the flat of the blade tilt handwheel onto the flat
of the blade tilt shaft, then secure.
20. Inspect the cast iron table for burrs or foreign
material that may inhibit installation of the extension
wings.
21. The mating edges of the table must be clean,
smooth, and flat. Use a wire brush or file if
necessary to clean up the edges. This step will
ensure that the wings will mount properly to the
main table.
22. With another person to hold the wings in place,
attach each extension wing to the main table with
(4) M8-1.25 x 20 hex bolts and (4) 8mm lock
washers.